Dispense Pump Programming: Encoded Pump

The Precision Auger pump uses a servo motor to control pump rotation. An encoder monitors auger position. Precise motion achieved by the encoder results in uniform dispensing with much greater accuracy than is available from a non-encoded pump.

When programming dots or singular dispenses, the operator may set the number of counts per dispense.

When programming lines or area fills, the operator may set the dispense rate of the pump.  This determines the constant speed of the pump during operation.

In both cases, the acceleration, deceleration, and reverse motion parameters can be set.  These parameters can be saved to a specific pattern (shape), placed in programs and used as often as you like. Being able to save dispense parameters with a specific pattern – not just to a single aspect of dispense – makes programming large varieties of product using similar components very easy.

Encoded Pump Auger Programming
Partial rotation is associated with dots.
Partial rotation is associated with dots
Constant rotation is associated with lines
Constant rotation is associated with lines.
Constant rotation is associated wtih lines
Micro Valve fluid dispensing parameters
additional Micro Valve fluid dispensing parameters
dispensed example of dots and lines pattern
Example of a pattern using dots and lines. Pattern may be called by multiple programs for use.
Top